When using NorCascade, it automatically displays the top level menu.
Is it possible to display the top two levels automatically and then have the cascade effect from level 2 down? Hope that make sense.
If you look at http://www.woodworkingcentreshop.co.uk I have the top level menu shown on the left column. There are two entries - "Product Range" and "Manufacturer". If you hover over either it displays the second level immediately below. I'd like that second level displayed all the time. Is that possible?
thanks
Andy[/url]
Always display top two menu levels
-
- Posts: 10
- Joined: Sat Nov 11, 2006 9:04 pm
OK - thanks for that Norman.
Perhaps I should explore other ways of achieving this.
Can Norcascade start at a lower level than the top level? I think I've seen that it can. But if I do that then I need to find some way of inserting the "Product Range" and "Manufacturer" labels in (which do not need to be clickable).
Or, if it can't start at a lower level, then perhaps I move all my subsections up to be sections - but I still need to find a way of inserting those labels at appropriate places.
Mmmmm. Needs some thought.
regards
Andy
Perhaps I should explore other ways of achieving this.
Can Norcascade start at a lower level than the top level? I think I've seen that it can. But if I do that then I need to find some way of inserting the "Product Range" and "Manufacturer" labels in (which do not need to be clickable).
Or, if it can't start at a lower level, then perhaps I move all my subsections up to be sections - but I still need to find a way of inserting those labels at appropriate places.
Mmmmm. Needs some thought.
regards
Andy